Notify Alert - AT&T SB67118 User Manual

Getting started
Mailbox setup (for general mailbox)

Notify alert

Use this feature to receive notification calls to your cell telephone or paging
device after each new telephone call message has been recorded to the
general mailbox. You can remotely access the message from a touch-tone
telephone (page 74). To receive notification calls, you must save your phone
number on the telephone base, and then set the system to call that number
after it finishes recording a message.
There is no message sent on the notification call. If the phone number called
has caller ID service, there will be an indication of the purpose of the call.
When you receive a notification call, you hear silence that lasts for about 15
seconds; then the call is ended. If no one picks up the call within three rings,
the telephone base cancels the call. The system only calls the alert number
once. If your paging device is busy, not available or off during the call, you
may not receive the notification call.
1. When the telephone is idle, press MENU
2. Press or
3. Press or
Set alert number:
ENTER again to select Alert call #.
1. Press
MENU/
2. Use the dial pad to enter the number (up to 32 digits) of
the telephone you want to be notified.
Press REMOVE to backspace and delete a digit.
•
Press REP or SKIP to move the cursor to the left or right.
•
• Press REMOVE to delete the left digit.
3. Press ENTER to save the setting and return to the previous menu.
MENU/
There is a confirmation tone. To exit without making changes, press EXIT.
Turn alert on or off:
1. Press or
2. Press or
3. Press ENTER to save the setting and return to
MENU/
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
to scroll to Mailbox setup. Press
to scroll to Notify alert. Press
to scroll to Alert on/off. Press
to scroll to On or Off.
.
/ENTER
MENU/
ENTER.
MENU/
MENU/
31
Set access code
Call screening
ENTER.
Notify alert
>
Remaining space
Alert call #
>
Alert on/off
Calling alert #
ENTER.
Alert on/off
:On
ENTER=Save