Removing The Cover And Bezel - IBM Netfinity 4500R User Reference Manual

Removing the cover and bezel

Removing the cover and bezel
r a n d b e z e l R e m o v i n g t h e c o v e
72
IBM® Netfinity® 4500R User's Reference
Refer to the following illustration to remove the cover and bezel.
Note: The illustrations in this document might differ slightly from your hardware.
Side latch
To remove the server top cover:
1. Review the information in "Before you begin" on page 66.
2. If you are planning to install or remove any part other than a hot-swap hard disk
drive, hot-swap power supply, or hot-swap fan, turn off the server and all
attached devices and disconnect all external cables and power cords.
3. Release the left and right side latches and pull the server out of the rack enclosure
until both slide rails lock.
Note: When the server is in the locked position, you can reach the cables on the
back of the server.
4. Lift the cover-release latch. Lift the cover off the server and set the cover aside.
Attention: For proper cooling and airflow, replace the cover before turning on the
server. Operating the server for extended periods of time (over 30 minutes) with
the cover removed might damage server components.
To remove the bezel:
1. Press in on the top sides of the bezel and pull the bezel away from the server
front.
2. Store the bezel in a safe place.
Cover-release latch
Side latch
Bezel