IBM Netfinity 4500R User Reference Manual page 130

POST message
1800 A PCI adapter has requested a hardware interrupt that is not available.
Action:
1962 No valid startup devices were found. The system cannot find the startup drive or
operating system.
Action:
If the same error message appears, call for service.
2400 An error occurred during the testing of the video controller on the system board. This
error can be caused by a failing monitor, a failing system board, or a failing video
adapter (if one is installed).
Action:
2462 A video memory configuration error occurred.
Action:
If the problem persists, call for service.
5962 An IDE CD-ROM configuration error occurred.
Action:
If the problem persists, call for service.
Table 15. POST error messages
118
IBM® Netfinity® 4500R User's Reference
1. Make sure that the PCI adapter and all other adapters are set correctly
in the Configuration/Setup Utility program. If the interrupt resource
settings are not correct, change the settings.
2. If all interrupts are being used by other adapters, you might need to
remove an adapter to make an interrupt available to the PCI adapter,
or force other adapters to share an interrupt.
Be sure that the drive you want to start from is in the startup sequence.
1. Select Start Options from the Configuration/Setup Utility program
main menu. If you are unable to set the startup sequence, call for
service.
2. Check the list of startup devices in the Startup device data fields. Is the
drive you want to start from in the startup sequence?
Yes Exit from this screen; then, select Exit Setup to exit the
Configuration/Setup menu. Go to step 3..
No Follow the instructions on the screen to add the drive; then,
save the changes and exit the Configuration/Setup menu.
Restart the server.
3. Is an operating system installed?
Yes Turn off the server. Go to step 4..
No Install the operating system in your server; then, follow your
operating system instructions to shut down and restart the
server.
4. During server startup, watch for messages indicating a hardware
problem.
Verify that the monitor is connected correctly to the video connector. If the
monitor is connected correctly, call for service.
Make sure that the monitor cables are correctly and securely connected to
the server.
Check the signal and power cable connections to the CD-ROM drive.
Description