IBM Netfinity 4500R User Reference Manual page 165

pnt0-2 PCI search specified, PCI device not found!
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action:
•
•
pnt0-6 Cannot allocate memory for the adapter during an interrupt. Please check your
Streams parameters.
Explanation: On a SunSoft Solaris system, this message indicates that the system is out
of Streams memory blocks.
Action: Use the CRASH utility to increase the number of Streams memory blocks.
Modify the interrupt request (IRQ) settings in the Configuration/Setup Utility
program, or run the NETCONFIG program to match the hardware settings.
pnt0-7 Cannot allocate memory for the adapter during reset. Please check your Streams
parameters.
Explanation: The system is out of Streams memory blocks.
Action: Use the CRASH utility to increase the number of Streams memory blocks.
pnt0-11 Device not found!
Explanation: The driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, run the diagnostic programs.
pnt0-12 Device failed checksum test!
Explanation: The driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, run the diagnostic programs.
pnt0-13 add_intr_handler failed! Interrupts already enabled.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was
found, conflicts with other devices in the server.
Action: Modify your hardware settings.
pnt0-14 Cannot locate hardware.
Explanation: The SunSoft Solaris driver cannot find any Ethernet controller.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, run the diagnostic programs.
pnt0-15 No more devices to open.
Explanation: The SunSoft Solaris driver cannot find any more Ethernet controllers.
Action: Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters are
present or replace the Ethernet adapter that fails to respond. If the problem persists,
run the diagnostic programs.
pnt0-17 Device fault...Reset initiated!
Explanation: The SunSoft Solaris driver has been reset due to a device fault.
Action: Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters are
present or replace the Ethernet adapter that fails to respond. If the problem persists,
run the diagnostic programs.
Table 25. UNIX LLI driver messages for the Ethernet controller
Run the NETCONFIG program to search for another Ethernet controller
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled,
run the diagnostic programs.
Troubleshooting
Chapter 7. Solving problems
153