Combination Switch - Mercedes-Benz 2016 Metris Operator's Manual

Switching on the standing lamps:
Turn the key to position 0 (
X
ignition lock or remove the key.
Right-hand standing lamp: turn the light
X
switch to position X.
Left-hand standing lamp: turn the light
X
switch to position W.

Combination switch

Turn signal lamps
To indicate a right turn
:
To indicate a left turn
;
To indicate: press the combination switch in
X
desired direction : or ; until it engages.
The combination switch automatically returns
to its original position after large steering
movements.
To indicate briefly: press the combination
X
switch briefly in desired direction : or ;.
The corresponding turn signal flashes three
times.
High-beam headlamps and high-beam
flasher
page 121) in the
Y
High-beam headlamps
:
High-beam flasher
;
To switch on the high-beam headlamps:
X
turn the light switch to L or Ã.
Press combination switch : forwards.
X
The K indicator lamp in the instrument
cluster lights up.
i
In the à position, the high-beam head-
lamps are only switched on when it is dark and
the engine is running.
To switch off the high-beam headlamps:
X
move the combination switch back to its nor-
mal position.
The K indicator lamp in the instrument
cluster goes out.
To operate the high-beam flasher: turn the
X
key to position 1 or 2 in the ignition lock.
Pull the combination switch briefly in direc-
X
tion of arrow ;.
Hazard warning lamps
G
If you open the rear doors 90°, the rear lights
are no longer visible. The vehicle will then be
difficult for other road users to see or will not
be seen by them at all, particularly if it is dark
or visibility is poor. There is a risk of an acci-
dent.
You should therefore ensure in this and simi-
lar situations that the vehicle is visible from
the rear in accordance with the relevant
national regulations, by using the warning tri-
angle, for instance.
Exterior lighting
WARNING
95
Z