Restarting - Mercedes-Benz 2016 Metris Operator's Manual

Tire pressure
278
positions for a short time. This is rectified after a
few minutes of driving; the tire pressures are
then displayed for the correct positions.
Restarting the tire pressure monitor
General notes
When you restart the tire pressure monitor, all
existing warning messages are deleted and the
warning lamp goes out. The monitor uses the
currently set tire pressures as the reference val-
ues for monitoring. In most cases, the tire pres-
sure monitor will automatically detect the new
reference values after you have changed the tire
pressures. However, you can also define refer-
ence values manually as described here. The tire
pressure monitor then monitors the new tire
pressure values.
Vehicles without steering wheel buttons
The vehicle must be stationary. Use the buttons
in the instrument cluster.
Turn the key to position 2 in the ignition lock.
X
Press È to select the
X
Press 3 to confirm.
X
The display shows the
message.
Press 3 to confirm.
X
The display shows the
message.
If you wish to confirm the restart:
Press the f button.
X
The display shows the distance menu.
After you have driven for a few minutes, the
system checks whether the current tire pres-
sures are within the specified range. The new
tire pressures are then accepted as reference
values and are monitored.
If you wish to cancel the restart:
Press g.
X
The display shows the tire pressure menu.
The tire pressure values stored at the last
restart will continue to be monitored.
Vehicles with steering wheel buttons
Using the steering wheel buttons
Make sure that the tire pressures of all four
X
wheels are set correctly for the current oper-
X
X
X
X
X
Tire Pressure Tire Pressure menu.
Monitoring Active Monitoring Active
X
Tire Pressure OK? Tire Pressure OK?
ating conditions. When doing so, observe the
notes under "Tire pressure" (
Turn the key to position 2 in the ignition lock.
Press = or ; to select the
menu.
Press 9 or : to select the
sure sure submenu.
Press a to confirm.
X
The display shows either the current tire pres-
sure for the individual tires, or the
pressure will be displayed after pressure will be displayed after
driving a few minutes driving a few minutes
Press the : button.
The display shows the Use Current Pres‐ Use Current Pres‐
sures as New Reference Values: sures as New Reference Values:
sage.
If you wish to confirm the restart:
Press the a button.
The display shows the Tire Press. Moni‐ Tire Press. Moni‐
tor Restarted tor Restarted message.
After you have driven for a few minutes, the
system checks whether the current tire pres-
sures are within the specified range. The new
tire pressures are then accepted as reference
values and are monitored.
If you wish to cancel the restart:
Press the % button.
The tire pressure values stored at the last
restart will continue to be monitored.
page 271).
Y
Service Service
Tire Pres‐ Tire Pres‐
Tire Tire
message.
mes-