Armrests - Mercedes-Benz 2016 Metris Operator's Manual

Seats
90
To move backwards: press and hold down
X
release button ; (luxury head restraints
only) and slide the head restraint back to the
desired position.
Let go of release button ; (luxury head
X
restraints only).
Ensure that the head restraint has engaged
X
properly.
The head restraints for the front seats or for a
standard rear bench seat can only be installed or
removed as described below.
To remove: pull the head restraint for the
X
front seat or standard rear bench seat up as
far as it will go.
Press release button : and pull out the head
X
restraint.
To install: insert the head restraints for the
X
front seat or standard rear bench seat such
that the rod with the detents is on the left
when viewed in the direction of travel.
Push the head restraint down until it engages.
X

Armrests

To adjust the armrest angle: fold the arm-
X
rest upwards by more than 45° to position
2.
The armrest is released.
Fold armrest 3 forwards to the stop.
X
Slowly fold the armrest upwards to the
X
desired position.
To fold the armrest up: if necessary, fold the
X
armrest upwards by more than 90° to posi-
tion 1.
Seat heating
G
WARNING
Repeatedly switching on the seat heating can
cause the seat cushion and backrest pads to
become very hot. The health of persons with
limited temperature sensitivity or a limited
ability to react to excessively high tempera-
tures may be affected or they may even suffer
burn-like injuries. There is a risk of injury.
Therefore, do not switch the seat heating on
repeatedly.
!
When you leave your seat, do not place any-
thing on the seat and switch off the seat heat-
ing. Do not switch the seat heating on when
the seat is not occupied, e.g. when driving
without a front passenger. The seat heating
may otherwise overheat, causing damage to
the seat.
The three red indicator lamps in the Í button
show the activated heating level 1 to 3.
The seat heating automatically switches down
from level 3 to level 2 after approximately seven
minutes.
The system automatically switches down from
level 2 to level 1 after approximately ten
minutes.
At level 1 the seat heating switches off auto-
matically after approximately 20 minutes.
Make sure that the key is in position 1 or 2 in
X
the ignition lock.
To switch on: press the Í button repeat-
X
edly until the desired heating level has been
set.
To switch off: press the Í button repeat-
X
edly until all indicator lamps go out.