Rescue Card - Mercedes-Benz 2016 Metris Operator's Manual

Mercedes-Benz tests genuine Mercedes-Benz
parts, conversion parts and accessories that
have been specifically approved for the type of
vehicle for:
Reliability
R
Safety
R
Suitability
R
Despite ongoing market research, Mercedes-
Benz is unable to assess other parts. Even if an
independent or official approval has been pro-
vided in exceptional cases, Mercedes-Benz
accepts no responsibility for the use of such
parts in Mercedes-Benz vehicles.
In some countries, certain parts are only offi-
cially approved for installation or modification if
they comply with legal requirements. All genu-
ine Mercedes-Benz parts satisfy these require-
ments. Make sure that all parts are suitable for
your vehicle.
Always specify the vehicle identification number
(VIN) ( page 295) and engine number when
Y
ordering genuine Mercedes-Benz parts
( page 296).
Y
QR code for rescue card
The QR Code stickers are affixed to the B-pillar
on the driver's and front-passenger side.
In the event of an accident the rescue services
use the QR Code to quickly find the rescue card
for your vehicle. The current rescue card con-
tains the most important information on your
vehicle, e.g. the electric cable routes, in a com-
pact form.
Further information can be found under http://
portal.aftersales.i.daimler.com.
Data stored in the vehicle
Data Recording
A wide range of electronic components in your
vehicle contain data memories.
These data memories temporarily or perma-
nently store technical information about:
the vehicle's operating state
R
events
R
faults
R
In general, this technical information docu-
ments the state of a component, a module, a
system or the surroundings.
These include, for example:
operating conditions of system components,
R
e.g. fluid levels
the vehicle's status messages and those of its
R
individual components, e.g. number of wheel
revolutions/speed, deceleration in move-
ment, lateral acceleration, accelerator pedal
position
malfunctions and defects in important system
R
components, e.g. lights, brakes
vehicle reactions and operating conditions in
R
special driving situations, e.g. airbag deploy-
ment, intervention of stability control sys-
tems
ambient conditions, e.g. outside temperature
R
This data is of an exclusively technical nature
and can be used to:
assist in detecting and rectifying faults and
R
defects
analyze vehicle functions, e.g. after an acci-
R
dent
optimize vehicle functions
R
The data cannot be used to trace the vehicle's
movements.
When your vehicle is serviced, technical infor-
mation can be read from the event data memory
and fault data memory.
Services include, for example:
repair services
R
service processes
R
warranty events
R
quality assurance
R
The vehicle is read out by employees of the ser-
vice network (including the manufacturer) using
special diagnostic testers. You can obtain more
information there, if required.
After a fault has been rectified, the information
is deleted from the fault memory or is continu-
ally overwritten.
When operating the vehicle, situations are con-
ceivable in which this technical data, in connec-
tion with other information (if necessary, after
consultation with an authorized expert), could
be traced to a person.
Introduction
33
Z