Removing - Mercedes-Benz 2016 Metris Operator's Manual

To unlock the sliding doors and the tail-
X
gate or rear door only: press the 5 but-
ton.
The turn signals flash once.
i
If you do not open the vehicle within approx-
imately 40 seconds of unlocking:
the vehicle is locked again.
R
the anti-theft protection is armed again.
R
To lock centrally: press the & button.
X
The indicator lamps flash three times if:
the anti-theft protection is armed.
R
all the doors and the tailgate or rear door
R
are closed.
Check the locking knobs on all the doors.
X
The locking knobs must all be in the lowered
position.
The key's factory setting enables you to cen-
trally lock and unlock the following:
the driver's and the front-passenger door
R
the sliding doors
R
the tailgate or rear door
R
In an emergency, the driver's door can also be
unlocked manually using the mechanical key
( page 69).
Y
You can also set an audible signal to confirm
that the vehicle has been locked. The audible
locking-verification signal can be switched on/
off:
using the on-board computer on vehicles with
R
steering wheel buttons (
at a specialist qualified workshop for vehicles
R
without steering wheel buttons
After unlocking using the remote control, the
surround lighting also goes on in the dark. For
vehicles with steering wheel buttons, the sur-
round lighting can be activated and deactivated
in the on-board computer (
Changing the settings of the locking
system
If you travel alone a lot, you may wish to change
the settings of the locking system. Press
the % button to unlock:
the driver's and front-passenger door (Cargo
R
Van)
or
the driver's door (Passenger Van)
R
X
If the setting of the locking system is changed
within the signal range of the vehicle, press the
& or % button to:
R
R
The key now functions as follows:
X
X
X
X
Mechanical key
General notes
If the vehicle can no longer be locked or
unlocked with the key, use the mechanical key.
The anti-theft alarm system (ATA) is triggered
when you unlock and open the vehicle using the
mechanical key (
page 188)
Y
The alarm can be disabled in the following two
ways:
X
or
X
page 187).
Y
Removing the mechanical key
To change the setting: press and hold down
the % and & buttons simultaneously
until the battery check lamp flashes twice.
( page 68).
Y
lock or
unlock the vehicle
To unlock the driver's door or front doors:
press the % button once.
To unlock centrally: briefly press the %
button twice.
To lock centrally: press the & button.
To restore factory settings: press and hold
down the % and & buttons simultane-
ously until the battery check lamp flashes
twice ( page 68).
Y
The key unlocks the vehicle centrally again.
page 67).
Y
Press the % or & button on the key.
Insert the key into the ignition lock.
SmartKey
69
Z