Cargo Compartment Lamp - Mercedes-Benz 2016 Metris Operator's Manual

Replacing bulbs: interior lighting and ambient lamps
98
Rear compartment and cargo com-
partment lamps
You cannot change the following bulbs yourself:
in a Passenger Van, the bulbs in the trunk
R
lamp and those of the rear interior lights in the
grab handles
in a Cargo Van with an LED light strip in the
R
cargo compartment, the LED light strip
Have these bulbs or the LED light strip changed
in a qualified specialist workshop only.
Information on changing the trunk lamp bulb in
the side trim panel of vehicles with cargo com-
partment partitioning can be found under "Addi-
tional interior and ambient lighting"
( page 98).
Y
Rear interior and cargo compartment lamp in the
headliner or side trim panel
Bulb type: T10 6W Xenon
Switch off the interior lighting.
X
Press in the spring catch of lamp lens : with
X
a suitable object, e.g. a screwdriver, and then
pry off lamp lens : with lamp housing =.
Press in spring catches ; and pull lamp
X
lens : off from lamp housing =.
Remove bulb ? from lamp housing =.
X
Insert new bulb ?.
X
For cargo compartment lamps with a button,
X
align lamp lens : so that its opening is above
the button of lamp housing =.
Position lamp lens : on lamp housing = and
X
engage.
Position lamp lens : with lamp housing =
X
on the left and engage.
Additional interior lighting and sur-
round lighting
The scope of the additional interior and ambient
lighting depends on your vehicle equipment. The
bulb change described here is valid for:
the mirror lamp in the sun visor
R
the ambient lamp at the bottom of the front
R
door
the ambient lamp inside the tailgate
R
You can find information on changing the bulb of
the signal and ambient lamp at the bottom of the
tailgate under "Signal and ambient lamp in the
tailgate" ( page 99).
Y
Type of lamp: W 5 W
Press in the catch spring of lamp housing :
X
with a suitable object, e.g. a screwdriver, and
pry off lamp housing :.
Turn socket ; counter-clockwise and
X
remove it from lamp housing :.
Remove bulb = from socket ;.
X
Press new bulb = into socket ;.
X
Screw socket ; clockwise into lamp hous-
X
ing :.
Position lamp housing : on the left-hand
X
side and engage.