Timer - FUTABA 6K Instruction Manual

Timer

TIMER
Function
The timer is convenient during a competition to
set the specified amount of time or the flying time
on a full tank of fuel.
●The timers can be set for each model. Since the
timers can be set to match the model, they do not
have to be reset each time the model is changed.
●The type of timer can be selected from among
up (UP), down (DOWN), and down stop (DN-STP).
The up timer is counted up from 0 and the elapsed
time is displayed on the screen. The down timer is
counted down from the set time and the remaining
time is displayed on the screen. The down stop
timer stops the count at 0. Each timer can be set
up to 99 minutes 59 seconds.
●Switches A to D, throttle stick (ST-THR), or power
switch (PWR-SW) can be selected as the start/
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
● Select the item with the
Jog key.
Time set up
Mode selection
ON Switch selection
Timer
■ Mode selection
Select timer mode
①
from the "MODE"
with the
＋ or － key.
＋ －
or
（Range）
UP, DOWN, DN-STP
"TIMER"
② Select
from the menu with the Jog
key.
Reset Switch selection
■ Timer time setting
② S e t t h e t i m e b y
pressing the + key or
– key at each TIME
(minutes):(second)
item.
（Range）
0 ～ 9 9 m i n u t e s 5 9
seconds
stop switch (START). The ON/OFF direction can
also be set. However, when the power switch was
selected, the timer starts when the power switch is
turned on.
●When the timer you want to reset is selected with
the Jog key and the Jog key is pressed for 1 second
at the home screen, the timer is reset. Switches A to
D can be selected as the reset switch (RESET). The
ON/OFF direction can also be set.
●The up/down timer audible alarm indicates the
time by a beep every second, continuous beeping
at 2 second intervals from 20 seconds before the
set time, and a continuous beeping at a 1 second
interval from 10 seconds before the set time.
③ Open the setting screen by
pressing the Jog key.
When the throttle switch is
●
selected at switch selection,
hold the throttle stick in the
position you want to set the
ON/OFF point at ON direction
setting and set the ON/OFF
position by pressing the Jog key
for 1 second. The timer is turned
ON at points higher than this
position. The ON direction can
be switched by pressing the +
key or – key.
Switch direction
■ Switch selection and ON direction setting
③ Select the switch by pressing the + key or – key at the
START or RESET item and set the ON direction by pressing
the + key or – key at the ON direction setting item.
(Switch setting range)
START: SwA 〜 D, THR, PWR
RESET: SwA 〜 D
(Switch ON direction)
3P SW: NULL (normally off), UP, UP&D, UP&C, CNTR, C&DN,
DOWN
2P SW: NULL, UP, DOWN
(Common)
91