Throttle Hold; Th Hold - FUTABA 6K Instruction Manual

Throttle hold

TH HOLD

Function
The throttle hold function fixes or stops the
engine throttle position by hold switch operation
during an auto rotation dive. Operation can be
set within the -50% 〜 +50% range based on the
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Activating the function
hold throttle position
● Select the setting item with
the Jog key.
Throttle hold
■ Activating the function
① Select the "MIX" item and then
select the "ON" or "OFF" by
pressing the + key or – key.
＋ －
or
● W h e n y o u d o n o t u s e a
function, set to the "INH" side.
● Function ACT ↔ INH is linked to
condition THR-HOLD, and can be set
at any screen.
throttle trim position.
The switch is changed at the conditions selection
screen. (Initial setting: SwD)
［NOTE］
Priority is given to throttle hold over idle-up.
"TH HOLD"
② Select
from the menu with the
Jog key.
■
Hold throttle position
② Select the "RATE" item and then adjust
the rate by pressing the + key or – key.
Range：-50 ～ +50%
Default：0%
● When you want to return the set value to the initial value, press
the + key and – key simultaneously.
【Hold position adjustment method】
● When you want to lower the engine idling, set to the "+" direction and
adjust so that the carburetor is full open.
● When maintaining idling, set the throttle stick to the slow position and
turn the hold switch on and off and set to the number at which the servo
does not operate.
NOTE：When connecting the throttle linkage, lower the digital trim to the
slowest and adjust so that the carburetor is full open.
CAUTION
③ Open the setting screen by
pressing the Jog key.
● When not using this Function
select INH. The display of On/
Off is shown when active and
assigned to a switch.
＋
(HELICOPTER)
－
or
131