Camber Mixing - FUTABA 6K Instruction Manual

Camber mixing

CMB MIX
Function
This function adjusts the rate of camber
operation for the wing camber (ailerons, flap) in
the negative and positive directions. The aileron,
flap, and elevator rates can also be adjusted
independently and attitude changes caused by
camber operation can be corrected.
All the wing control surfaces are
lowered and the camber is increased
(lift increases)
Attitude changes are compen-
sated for by setting the
amount of elevator movement.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Sets the amount of
movement when
the VR was turned.
● Aileron 1
● Aileron 6
● Flap 5
● Flap 3
( R T 1 ) ： T h e a m o u n t o f
operations when VR is turned to
the right.
● Amount of compensation
of the elevator when the
camber changed.
● Camber MIX ACT/INH
● Can be set to operate from
a switch. When NULL, it is
operated by a VR.
WING TYPE 1AIL
*Initial setting assigns camber operation to VR.
● Operation can be turned on and off by switch
● VR can be changed by AUX channel 5
Turn the VR
Attitude changes are compen-
sated for by setting the
amount of elevator movement.
"CMB MIX"
② Select
from the menu with the
Jog key.
（Currently selected condition）
[CMB MIX ２page] （Currently selected condition）
1AIL1FLP 2AIL 2AIL1FLP 2AIL2FLP
All the wing control surfaces are
raised and the camber is
decreased (lift decreases)
③ Open the setting screen by
pressing the Jog key.
● Select the setting item
with the Jog key.
＋
● The value is changed by
+ key or – key.
( R T 2 ) ： T h e a m o u n t o f
operations when VR is turned to
the left.
● When condition is used, the
display can be switched and
each connection can be set by
switching the condition switch.
● Sets the ON/OFF direction of
the selected switch.
(GLIDER)
－
147