Fuel Supply Pump Removal And Installation - Mitsubishi 6M70 Workshop Manual

MITSUBISHI 6M70 FUEL SUPPLY PUMP
Removal sequence
1 Fuel pipe
2 Eyebolt
3 Fuel suction pipe
4 Eyebolt
5 Fuel feed pipe
6 Eyebolt
WARNING
• Fuel is highly flammable. Do not handle it near flames or heat.
• Spilled fuel may catch fire and therefore, must be wiped off completely.
CAUTION
• Any contamination of the supply pump, even if it is minor, will greatly affect the performance of the en-
gine. After removing pipes, hoses, or other parts, plug the openings with covers. Wash eyebolts and new
gaskets in light oil and keep them away from contaminants.
• Contact Bosch Service Station for any service needs of the supply pump.
Installation sequence
Follow the removal sequence in reverse.
CAUTION
• Make sure that the harness (marked with " ") of MPROP (rail pressure control valve) is connected to the
supply pump before starting the engine. Starting the engine without connection causes a malfunction.
13-66
7 Fuel feed pipe
8 Over flow valve
9 Fuel return pipe
10 Eyebolt
11 Oil pipe
12 Supply pump
13 O-ring
* a: Flywheel housing
* b: Rear plate
: Non-reusable parts