Configure The Settings Relating To Panasonic Alarm Protocol [Notification] - Panasonic WV-SW598 Operating Instructions Manual

13 Configure the alarm settings [Alarm]
Destination of notification
[Address 1] - [Address 4]
Enter the destination E-mail address. Up to 4 destination E-mail addresses can be registered.
•
[Alarm] checkbox: When the checkbox is selected, the E-mail notification will be performed upon an alarm
occurrence.
•
[Diag.] checkbox: When the checkbox is selected, the E-mail notification will be provided in the following
cases.
–
When notification of the remaining capacity of the SD memory card has been provided
–
When the SD memory card has become full
–
When the SD memory card cannot be recognized
•
[Destination E-mail address]: Enter the destination E-mail address.
–
Available number of characters: 3 - 128 characters
–
Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_),
and the hyphen (-).
To delete the registered address, click the [Delete] button respective to the desired address.
[E-mail subject]
Enter the E-mail subject.
•
Available number of characters: 0 - 50 characters
[E-mail body]
Enter the E-mail body.
•
Available number of characters: 0 - 200 characters
Note
•
Notification E-mail will be sent with the message "The capacity of the SD memory card is full." when
the SD memory card has become full, or "The SD memory card cannot be detected." when mounting
of the SD memory card failed.
13.10 Configure the settings relating to Panasonic
alarm protocol [Notification]
Click the [Notification] tab on the "Alarm" page. (®page 47, page 49)
146 Operating Instructions