Panasonic WV-SW598 Operating Instructions Manual page 90

11 Configure the settings relating to images and audio [Image/Audio]
•
Available IPv4 address: 224.0.0.0 - 239.255.255.255
•
Available IPv6 address: Multicast address starting with "FF"
•
Default:
–
H.264(1): 239.192.0.20
–
H.264(2): 239.192.0.21
Note
•
Enter a multicast IP address after checking available multicast address.
[Multicast port]
*3
Enter the multicast port number (used to transmit images from the camera).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default: 37004
Note
•
When audio is transmitted from the unit, the port number to be used will be the multicast port number
plus "1000".
[Multicast TTL/HOPLimit]
Enter a value for "Multicast TTL/HOPLimit".
•
Available value: 1-254
•
Default: 16
IMPORTANT
•
When transmitting an H.264 image via a network, the transmitted image sometimes may not be
displayed depending on the settings of a proxy server or a firewall. In this case, refer to the network
administrator.
•
When two or more network interface cards are installed on the PC in use, the network interface card(s)
not used for receiving images should be invalidated when displaying images using the multicast port.
[Smoother live video display on the browser (buffering)]
Perform settings to display camera images on the viewer software.
•
On: Images are temporarily stored on the computer and are displayed smoother.
•
Off: Images are displayed in real-time and are not stored on the computer.
•
Default: Off
[Initial display stream on the browser]
Configure what type of images are initially displayed on the "Live" page.
H.264: Initially displays H.264 images on the "Live" page.
JPEG: Initially displays JPEG images on the "Live" page.
Default: H.264
Note
•
Even when "H.264" is selected, if "Off" is selected for "H.264 transmission", only JPEG images are
displayed.
*1 It is not possible to configure this setting for both H.264(1) and H.264(2) simultaneously.
*2 It is necessary to designate the unicast port number when "Unicast port (MANUAL)" is selected for "Transmission type".
*3 It is necessary to designate the multicast IP address when "Multicast" is selected for "Transmission type".
90 Operating Instructions
*3