Configure The Settings Relating To The Alarm Image [Alarm] - Panasonic WV-SW598 Operating Instructions Manual

13 Configure the alarm settings [Alarm]
The sender's address for the command alarm, and the preset position for that address can be registered in
this section.
[Sender's address 1] - [Sender's address 8]
Set the sender's IP address for the command alarm, and the preset position for that address. Up to 8 notification
addresses can be set.
•
[Auto track cooperation] checkbox: When the checkbox is selected, auto tracking starts after the
direction of the camera moves to the preset position.
[Close] button
Click this button to close the "Preset per sender" setup menu.
13.3 Configure the settings relating to the alarm
image [Alarm]
Click the [Alarm] tab on the "Alarm" page. (®page 47, page 49)
The settings relating to the alarm image to be transmitted to an FTP server can be configured in this section.
The alarm image will be transmitted to an FTP server. To transmit alarm images to an FTP server, it is
necessary to configure the settings in advance. (®page 157)
IMPORTANT
•
Depending on the network line speed or the network traffic, images may not be transmitted at the exact
designated interval or period.
•
When "Alarm input" or "Manual" is selected for "Save trigger" on the [SD memory card] tab, images will
not be transmitted to the FTP server even when an alarm is detected. Set "Save trigger" to "FTP
error". (®page 59)
134 Operating Instructions