Configure The Settings Relating To The Audio Detection [Audio Detection] - Panasonic WV-SW598 Operating Instructions Manual

13 Configure the alarm settings [Alarm]
The status bar will be indicated in the "Detection area" section to show the motion detection status of the
currently displayed area.
When the status bar exceeds the setting position of slider, the alarm action will be performed.
Note
•
When "Detection area" cannot be adjusted properly by moving the slider, adjust "Detection
sensitivity" while checking the motion detection status.
3.
Click the [Set] button after completing the settings.
IMPORTANT
•
The setting will not be applied unless the [Set] button is clicked.
4.
To invalidate the VMD area, click the [Set] button after selecting "Off" for "Status" of the VMD area to be
invalidated.
→
The outline of the invalidated VMD area will turn to a dotted line. When the VMD area is invalidated,
no alarm will occur even when a motion can be recognized in the area.
5.
To delete the VMD area, click the [Delete] button corresponding to the area to be deleted.
→
The outline of the respective VMD area will disappear.
6.
Click the [Set] button.
→
The edited settings will be applied.
7.
Click the [Back] button to return to the screen to select a preset position.
13.8 Configure the settings relating to the audio
detection [Audio detection]
Click the [Audio detection] tab on the "Alarm" page. (®page 47, page 49)
The settings relating to audio detection can be configured in this section. When the configured audio detection
level is exceeded, the alarm action will be performed.
The audio detection level can be adjusted in 10 levels.
In order to use the perform audio detection, audio settings must be configured. (®page 125)
IMPORTANT
•
The alarm occurrence indication button will be displayed when sound is detected by the audio detection
function. (®page 9)
•
The alarm occurrence indication button will also be displayed when receiving an alarm input of a
terminal alarm or a command alarm.
•
Notification may be delayed in some network environments even when "Real time" is selected for
"Alarm status update mode" on the [Basic] tab of the "Basic" page. (®page 53)
142 Operating Instructions