Design Information For Wall Instal- 17. 1 Vitosol-F Flat-Plate Collectors, Type Sh; Collector Supports - Angle Γ 10 To 45 - Viessmann VITOSOL 100-F SV Technical Manual

Design information on flat roof installation
A
A Support slab A
B Support slab B
Design information for wall installation
17.1 Vitosol-F flat-plate collectors, type SH
Observe the information on securing collectors on page 111.
The collector supports are pre-assembled. They consist of a base rail,
a collector support and adjustable supports. The adjustable supports
contain holes for adjusting the angle of inclination.
Collector supports – angle γ 10 to 45°
γ
C
γ= 10°
γ= 15°
γ= 20°
γ= 25°
γ= 30°
γ= 35°
γ= 40°
γ= 45°
A Base rail
B Adjustable support
C Collector support
D Wall
VITOSOL
(cont.)
■ Type SP2A
The yield can be optimised by rotating the vacuum tubes 25° to the
horizontal.
■ Type SPE
The yield can be optimised by rotating the vacuum tubes 45° to the
B horizontal.
The fixing materials, e.g. screws, are to be provided on site.
11
D
A
B
Base rail hole dimensions
80
50
50
17
VIESMANN
135