Installation on walls (only Vitosol 200-T)
Vitosol 200-T
a
2
1.26 m
2
1.51 m
2
3.03 m
90°
Ø9
9.
10.
Information on step 10:
Use the centring groove on the back of
the header casing as a drilling guide.
Horizontal (flat) installation (only Vitosol 200-T)
For example on flat roofs
54
mm b
mm
210
260
230
265
480
515
(cont.)
Install the header casing offset against
the tube retainer. This inclines the vac-
uum tubes towards the horizontal.
8.
Continue with chapter "Hydraulic con-
nections" (see page 68).
Installation information
■ Observe the maximum load and dis-
tance from the edge of the roof, sub-
ject to the on-site substructure, in com-
pliance with DIN 1055.
■ Remove any gravel or similar from the
installation area. Cover the area with
protective building mats and position
support slabs A and B on top of these
mats (see following illustration).