Vitosol 200-T And Vitosol 300-T Vacuum Tube Collectors (On Supports) - Viessmann VITOSOL 100-F SV Technical Manual

Design information on flat roof installation
16
A Joining plate
B Cross brace
C Concrete slabs (on site)
or
D On-site substructure, e.g. steel beams (on site)
Type SV
x in mm
y in mm
z in mm See page 128.

16.3 Vitosol 200-T and Vitosol 300-T vacuum tube collectors (on supports)

Observe the information on securing collectors on page 111.
VIESMANN
132
(cont.)
D
SH
597 1921
480 480
See page 128.
A
B
C
D
Viessmann offers two collector supports for fixing the collectors:
■ With variable angles of inclination of 25 to 50° (snow loads up to
2
2.55 kN/m , wind speeds up to 150 km/h):
The collector supports are pre-assembled. They consist of the base
rail, collector support and adjustable support with holes for adjusting
the angle of inclination (see the following chapter).
■ With a fixed angle of inclination (snow loads up to 1.5 kN/m
speeds up to 150 km/h):
Collector supports with mounting feet (see from page 134).
For this version the angle of inclination is calculated from the dis-
tance between the mounting feet.
Cross braces are required for 1 to 6 collectors connected side by side
to secure the support.
2 , wind
VITOSOL