Yamaha RIVAGE PM10 Operation Manual page 91

Monitor  OSCILLATOR
PINK NOISE:
• LEVEL knob
Indicates the output level of the pink noise. Use the screen encoder to adjust the value.
• HPF knob
Indicates the cutoff frequency of the HPF that processes the pink noise. Use the screen
encoder to adjust the value. Use the button below the knob to switch the HPF on or off.
• LPF knob
Indicates the cutoff frequency of the LPF that processes the pink noise. Use the screen
encoder to adjust the value. Use the button below the knob to switch the LPF on or off.
BURST NOISE:
• LEVEL knob, HPF knob, LPF knob
These are the same as for the PINK NOISE mode.
• WIDTH knob
Indicates the length of noise being output intermittently. Use the screen encoder to adjust
the value.
• INTERVAL knob
Indicates the length of silence between noise bursts. Use the screen encoder to adjust the
value.
Level
Pink noise output
INTERVAL
WIDTH
The BURST NOISE button is turned on.
Time
91
3 ASSIGN section
Enables you to select a channel to which the oscillator signal will be sent. Press one of the five
tabs below to select the type of channels/buses displayed, and then press the button(s) for the
desired channels/buses (multiple selections are allowed).
If SINE WAVE 2CH mode is selected, output signals will vary depending on whether the
selected channel number is odd or even. For example, the odd-channel signal will be routed to
MIX1 and the even-channel signal will be routed to MIX2. You can press the CLEAR ALL
button to defeat all selections.
4 Channel display select buttons
Select the type of channels that you want to view on the screen. Available options are CH1-72,
CH73-144, MIX, and ST/MTRX, MONITOR.
5
Meter section
Indicates the oscillator output level.
6
OSCILLATOR OUTPUT button
Turns the oscillator on or off. If this button is turned on, the oscillator signal will be sent to the
input channel or bus you selected in the ASSIGN section. When you press the button again,
the oscillator will turn off.
7 CLEAR ALL button
Excludes all output channels from the oscillator signal destination.
8 CLOSE button
Closes the OSCILLATOR popup window.
3.
Press a button in the MODE field to select the type of signal you want to output.
4.
Use the knobs and buttons in the parameter field to adjust the oscillator
parameters.
The displayed parameters will vary depending on the oscillator selected in the MODE field. To
control the knobs shown in the parameter field, use the corresponding screen encoders.
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ