Send Point (Input Specifying The Send Point For Each Input Channel) - Yamaha RIVAGE PM10 Operation Manual

System Setup  BUS SETUP
SEND POINT (INPUT)
(Specifying the send point for each input channel)
You can select the send destination points for each channel. The send point can be specified for both
when the send source channel is set to PRE and set to POST individually.
1.
Press the SETUP button to access the SETUP screen.
2.
Press the BUS SETUP button to open the BUS SETUP popup window.
This window includes several pages, which you can switch between using the tabs located at
the top of the window.
3.
Press the SEND POINT (INPUT) tab.
The screen contains the following items.
1
1 Channel select list
Enables you to select a channel.
2 ALL button
Press this button to apply the selected send point to all channels simultaneously.
If the send point is not selected for some channels in the column, "... " will appear.
3
PRE send point select buttons
Enable you to select the send point for each channel for which PRE is turned on. These buttons
correspond to the following parameters.
Button
PRE FILTER
PRE EQ
PRE DYNA1
PRE DYNA2
PRE FADER
67
CONTENTS FUNCTION MAP
2
3 4
Send Point
Immediately before the filter
Immediately before the EQ
Immediately before DYNAMICS1
Immediately before DYNAMICS2
Immediately before the fader
RIVAGE PM10 Operation Manual
FAQ
5
6