Loading A File From A Usb Flash Drive - Yamaha RIVAGE PM10 Operation Manual

File  Loading a file from a USB flash drive

Loading a file from a USB flash drive

Follow the steps below to load the RIVAGE PM10 system setting file (extension .PM10ALL) from
the USB flash drive into the console.
You can use the same procedure to load the following files other than the setting file.
Extension Type Contents of file
.PM10ALL ALL Internal setting file for the RIVAGE PM10 system
.BMP BMP Image file for display in the CONSOLE LOCK screen (256 or more
colors, uncompressed bitmap format)
.jpg JPG Image file for display in the CONSOLE LOCK screen (JPEG format)
.png PNG Image file for display in the CONSOLE LOCK screen (PNG format)
NOTICE
Some data may contain settings that will cause the console to output signals immediately after the
data is loaded. Therefore, before loading data, turn off the power to the equipment connected to the
control surface and/or lower the volume of such equipment so that there will not be a problem even if a
signal is output from the control surface.
1.
Press the SETUP button on the menu bar to access the SETUP screen.
2.
Press the SAVE/LOAD button to access the SAVE/LOAD popup window.
1
1
Tabs
Use these tabs to switch between SAVE and LOAD.
2
LOAD button
Loads the selected RIVAGE PM10 system setting file.
3.
Press the LOAD tab to switch to the LOAD window.
4.
To select the file that you want to load, press the name of the desired file in the
file list, or rotate the corresponding screen encoder on the panel.
5.
Press the LOAD button. A confirmation dialog box will appear.
6.
Press the OK button to begin loading the file.
When the file has finished loading, the PROCESSING popup window that shows the progress
of the loading operation will close.
218
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ
2