Yamaha RIVAGE PM10 Operation Manual page 55

System Setup  SYSTEM CONFIG
6 Sampling rate select menu
Selects the output sampling rate when an SRC is turned on.
Choose from SAME AS INPUT (same as the word clock that is input), 44.1 kHz, 48 kHz,
88.2 kHz, or 96 kHz.
7
GAIN knob
Adjusts the output gain of the output port. You can use the screen encoders to make
adjustments. Adjust the setting in 1.0 dB units by turning the knob, or adjust the setting in
0.1 dB units by turning the knob while pressing it. The current value is shown immediately
below the knob.
8 Level meter
Indicates the output level of the signal after level adjustment.
9 Tabs
Switch the input and output display in units of eight channels.
MY CARD INPUT
1
2
3 4
5
1 Patch indication
Indicates the channel that is patched.
2 Level meter
Shows the input level.
3
SRC button
Switches the sampling rate converter on/off for each pair of channels.
NOTE
This setting will be ignored if you try to specify it for an MY card that does not support SRC.
4 Clock status display
Indicates the status of the input signal.
5 PHASE button
Switches the phase of the input signal.
NOTE
This is an internal SLOT parameter. It is different than the Ф parameter within the channel
module of the control surface.
6
Tabs
Switch the input and output display in units of eight channels.
55
CONTENTS FUNCTION MAP
6
RIVAGE PM10 Operation Manual
FAQ