Using The 31Bandgeq - Yamaha RIVAGE PM10 Operation Manual

GEQ/PEQ  Graphic EQ and parametric EQ

Using the 31BandGEQ

1.
Follow steps 1–6 under "Inserting a GEQ/PEQ into a
the 31BandGEQ into a channel.
The system displays the EDIT screen for the GEQ/PEQ that you inserted.
1
@
1 MOUNT GEQ/PEQ popup button
Press this button to access the MOUNT GEQ/PEQ popup window.
2 EQ graph
Indicates the approximate current response of the 31BandGEQ.
3
GEQ LINK button
Press this button to access the GEQ LINK window, in which you can link the GEQ of paired
channels.
NOTE
The GEQ LINK button appears only for paired GEQs.
4
FLAT button
Press this button to reset the GAIN parameters of all GEQ bands to 0 dB.
channel" (page 148), insert
2 $ 3 4 5
6
8
! #
5 GEQ ON button
Switches the currently-selected GEQ on or off.
6 EQ button
Press this button to display the EQ graph.
7
RTA button
If this button is on, a semi-opaque frequency analysis graph of the input signal (immediately
after EQ) will be superimposed on top of the EQ frequency response graph.
8 PEAK HOLD
If this button is on, the analyzed frequency response graph will hold the peak level indication.
9 HOLD button
7
If this button is on, the frequency response graph will indicate and hold the result of the
frequency analysis.
9
)
)
BALLISTICS field
• BALLISTICS button
If this button is on, you will be able to add rate of decay to the analyzed frequency response
graph.
• FAST/SLOW switch button
Switches the decay rate of graph rendering (FAST/SLOW).
! Faders
Indicate the amount of boost and cut for each band of the 31BandGEQ. The actual values are
shown in the numerical boxes below.
@ FADER ASSIGN field
In this field you can select the group of bands that will be controlled by the faders in the
Channel Strip section.
#
LIMIT select buttons
Enable you to select the range of gain adjustment from the following options: ±15 dB, ±12 dB,
±6 dB (these are valid in both the boost and cut directions), or –24 dB (valid only in the cut
direction).
$
DEFAULT button
Press this button to restore the default parameter setting.
2.
If you are using a stereo source, link two GEQ units.
When you press the GEQ LINK button, the following popup window will appear. To enable
linking, press any button other than CANCEL.
152
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ