About Cue Mode And Solo Mode - Yamaha RIVAGE PM10 Operation Manual

Monitor  CUE
CUE
The RIVAGE PM10 features two cue outputs: CUE A and CUE B.
You can also use a very flexible Cue/Solo function.

About Cue mode and Solo mode

All input channels, output channels, and DCAs feature the [CUE] key for the Cue/Solo function.
The [CUE] key provides two modes: Cue mode and Solo mode. These modes differ as follows.
• Cue mode
If you press the [CUE] key for the channels or DCAs, the corresponding cue signals will be sent to
the dedicated CUE bus and then output from MONITOR OUT, PHONES OUT, and CUE OUT
(Cue function). Choose this mode if you want to monitor certain channel signals without affecting
other output buses.
• Solo mode
If you press the [CUE] key for the channels or DCAs, only the solo signals will be output from the
MIX/MATRIX/STEREO buses. Other channels/DCAs will be muted (Solo function).
The same signal can also be monitored from MONITOR OUT, PHONES OUT, and CUE OUT.
NOTE
In Solo mode, you can exclude specific certain channels from Solo operations
About cue/solo groups
The cue signals can be categorized into the following four groups.
1 OUTPUT CUE group
The cue/solo signals of output channels make up this group. To switch
Cue/Solo for this group, in the Channel Strip section, press the
OUTPUT [MIX]/[MATRIX] key, and then press the desired [CUE]
key.
Channel Strip section: [CUE] keys,
(page 87).
OUTPUT [MIX]/[MATRIX] keys
2 DCA CUE group
The cue/solo signals of DCAs make up this group. To enable Cue/Solo
for this group, in the Channel Strip section, press the [DCA] key, and
then press the desired [CUE] key.
3
INPUT CUE group
The cue/solo signals of input channels make up this group. To enable
Cue/Solo for this group, in the Channel Strip section, press the INPUT
[1-72]/[73-144] key, and then press the desired [CUE] key.
4
Other CUE group
These cue signals are operated via buttons displayed on the touch screen.
This group is enabled if you turn on the KEY IN CUE button in any plug-
in's popup window or in the DYNAMICS 1/2 popup window. This group
will automatically be disabled when you exit the corresponding popup
window. You cannot turn Cue on for different groups simultaneously.
Normally, the group to which the most recently-pressed [CUE] key (or on-
screen CUE/KEY IN CUE button) belongs will take priority, and the [CUE] keys for the
previously-selected group will be defeated.
However, if you have switched the cue signal group in a specific order when the CUE MODE
setting is MIX CUE, the state of the [CUE] keys for the previously-selected group will be
restored when the current cue signal is defeated.
82
CONTENTS FUNCTION MAP
Channel Strip section:
[CUE] keys, [DCA] key
Channel Strip section:
[CUE] keys,
INPUT [1-72]/[73-144] keys
On-screen
CUE buttons
RIVAGE PM10 Operation Manual
FAQ