Patching For Multitrack Recording And Virtual Sound Check - Yamaha RIVAGE PM10 Operation Manual

Recording  Multitrack recording/virtual sound check

Patching for multitrack recording and virtual sound check

HY card slot 4 on the DSP engine (DSP-R10) is used for multitrack recording exclusively. HY card
slot 4 features the Recording Patch function for recording and playback. Patch channels (into which
you want to perform multitrack recording) to the ports of HY card slot 4.
1.
Press the PATCH button on the menu bar to access the PATCH screen.
This screen includes several pages, which you can switch between using the tabs located at the
top of the screen.
2.
Press the RECORDING tab to open the RECORDING PATCH screen.
NOTE
To display the patch grid, you must specify HY144-D for HY card slot 4 in the DSP engine. (You
can also do so off-line.)
7
#
4 6
1 2 5
9 !
7
6
8 )
3 3
1 Category select list (channel)
You can select the channel category using the knob. The categories correspond to the following
channels.
• CH1–144
• MIX1–72
• MTRX 1-36
• STEREO AL-BR
2 Channel display
This area indicates channels that can be assigned to the RECORDING slot.
3 Grid
This grid lets you patch output jacks (horizontal lines) to channels (vertical columns).
Currently-patched grids are indicated by white squares. Press or click a desired grid to set or
disable the patch.
4 ALL button
All channels will be subject to or excluded from the virtual sound check simultaneously. If any
one channel is turned off, this button will indicate "... "
5
Check buttons
Enable you to select channels that are subject to the virtual sound check.
6
Continuous Patch
Press the continuous patch
intersecting channels continuously.
If you press the continuous patch
Press the button again to confirm the selected continuous patches. Press the
to revert the continuous patches to the previous state.
7 UNDO button
Press this button to revert the continuous patches to the previous state.
8 REC OUT ASSIGN
This area indicates the number of REC OUTs assigned to each channel.
9 REC OUT select knob
Enables you to select a channel used for REC OUTs.
) PLAYBACK IN ASSIGN
This area indicates the number of PLAYBACK INs assigned to each channel.
! PLAYBACK IN select knob
@
Enables you to select channels used for PLAYBACK INs.
192
CONTENTS FUNCTION MAP
button
button, and then rotate the REC OUT select knob to patch the
button, the button and the
RIVAGE PM10 Operation Manual
FAQ
button will appear.
button