Engine/Job Separator - Konica Minolta bizhub C200 Service Manual

Field Service Ver. 1.0 Jun. 2008
8. Reinstall the cover of the slot.
9. Turn ON the main power switch and the sub power switch.
10. Select [Admin.] → [Firmware Version].
11. Check that the firmware version has been updated.
5.2.2

Engine/job separator

NOTE
• Make sure that the controller firmware is not copied to the compact flash.
• To rewrite both the engine and job separator firmware at the same time, copy both
types of firmware to the compact flash.
• If wrong files are copied to the compact flash, no display is given on the control
panel.
1. Turn OFF the main power switch.
[1]
A02FF2C526DA
[1]
A02FF2C525DA
5. Firmware upgrade
7. Remove the compact flash card [1]
from the slot.
2. Remove the cover [1] from the com-
pact flash insertion slot.
33