File Dump; 10.8 State Confirmation; Sensor Check - Konica Minolta bizhub C200 Service Manual

10. Service Mode
10.7.3

File Dump

Functions • To specify the file for analysis which can be output inside the controller, and print it.
Use • To analyze troubles.
Setting/ 1. Call the Service Mode on the screen.
2. Touch [List Output] → [File Dump].
Procedure
3. Enter the file name of the file to be printed.
4. Press the start key to print the file.

10.8 State Confirmation

10.8.1

Sensor Check

Functions • To display the states of the input ports of sensors and switches when the machine
remains stationary.
Use • Used for troubleshooting when a malfunction or a misfeed occurs.
Setting/ • The operation of each of the switches and sensors can be checked on a real-time
Procedure basis.
• It can be checked as long as the 5-V power line remains intact even when a door is
open.
A. Electrical components check procedure through input data check
• When a paper misfeed occurs in the paper feed section of the machine, the sensor in
front of tim. roller is considered to be responsible for it.
1. Remove the sheet of paper misfed.
2. From the sensor check list that follows, check the panel display of the sensor in front of
tim. roller. For the sensor in front of tim. roller, you check the data of "Timing Roller."
3. Call the Service Mode to the screen.
4. Touch [State Confirmation] → [Sensor Check (Printer)] in this order, and select the sen-
sor check screen which includes "Timing Roller."
5. Check that the data for "Timing Roller" is "0" (sensor blocked).
6. Move the actuator to unblock the sensor in front of tim. roller.
7. Check that the data for "Timing Roller" changes from "0" to "1" on the screen.
8. If the input data is "0," change the sensor.
256
Field Service Ver. 1.0 Jun. 2008