Table of Contents
Advertisement
INSTALLATION
7. Remove the 12 screws securing the valve tray assembly in place
(Diagram 3. and then lift the entire assembly out.
8. Manoeuvre fan into valve tray opening at base of fi rebox.
9. Secure fan by pushing fan down onto mounting pins located on fl oor of
unit. Take care not to damage the insulation on the fan base. Ensure
that the fan blades do not rub against the valve tubing. Diagram
5.
10. Connect fan ground cable to ground lug. Refer to wiring diagram.
11. Slide the thermodisc/cover assembly into the bracket clip on the
underside of the fi rebox (Diagram 6 ).
Check that no wires will touch the hot surfaces.
40
Diagram 3
Diagram 4
Diagram 5
Diagram 6
12. Remove lower base cover by lifting out (Diagram 7.
Diagram 7
13. Attach the fan control box to the Control Plate. (Diagrams 8 & 9).
Fan Control Box
Control Mounting Plate
Diagram 8
14. Position the control plate assembly on the left hand side of the fi rebox.
Diagram 10
15. Secure the control plate assembly with 1 screw as shown in Diagram
11.
Diagram 10
16. Secure the fan wires and power cord by attaching one of the adhesive
backed wire holder clips (Part #910-199. onto the Fireplace base.
Use the second clip to bundle up the wires approximately 4" from the
control box. Ensure that there is no interference with the wires when
the faceplate and trim are installed and that no wires will touch the hot
metal surfaces or sharp edges.
17. Plug the fan power cord into the rear end of the receptacle box to
provide the maximum clearance.
18. Reverse Step 1-7.
TO REMOVE THE FAN
1. Shut the power off.
2. Reverse the above instructions.
Note: The bearings are lubricated for life. Do not lubricate them.
Make sure you vacuum the fan area on a regular basis.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure you
maintain these fan motors on a regular basis by vacuuming out the
fan blades and housing using a soft brush nozzle.
Diagram 9
Diagram 11
Regency HZ33CE Gas Fireplace
Advertisement
Table of Contents
