Table of Contents
Advertisement
9. Place Left Log (2 ) match pin landing on Log 2 with pin on Log 1, the
bottom should rest on the glass as shown below.
HZ33CE shown - Left Log (2) positioned to rest on Log 1 and
10. Adjust position of Log 4 – log should sit as shown below, 14" from
the left outside of the burner tray.
14"
11. Position Log 3, line up bottom pin landing on Log 3 with pin on
Log 1. The remainder of Log 3 will rest on the burner tray.
1
5
2
12. Place lava embers/rocks on glass - ensure rocks do not block pilot.
Do not place lava rocks/embers too close to logs as this may cause
carboning.
13. Adjust aeration, see unit manual for setting.
HZ33CE shown - Final Install
Regency HZ33CE Gas Fireplace
2
HZ33CE use bottom
pin landing
1
glass crystals.
1
2
4
HZ33CE use
bottom pin
landing
4
HZ30E INSTALL INSTRUCTIONS:
1. I nstall the log clips on the burner tray - measure 2-1/2" from theoutside
edge of the pilot hood to the outside edge of the log clip.
2. Position Back Log (1) by positioning centre of Log on centre of pilot
hood.Rest Log 1 on log clips.
Each end should rest on the lip of the burner tray – as shown below.
3
HZ30E shown - Log 1 in position
3. Position Log 2, line up pin landing on Log 2 with pin on Log 1, remainder
of Log 2 rests on the burner tray as shown below.
HZ30E shown - installing Log 2
INSTALLATION
Log clips installed
HZ30E
HZ30E use top
pin landing
45
Advertisement
Table of Contents
