Table of Contents
Advertisement
Removing Valve
1. Shut off the gas supply.
2. Remove the faceplate.
3. Open the fl ush door and remove the door.
4. Remove 6 screws in locations shown below to remove base tray and
pilot hood (See Diagram 1..
Diagram 1: Remove the 6 screws and then lift
out the base tray
5. Remove 2 screws in location shown below - slide burner to the right
then lift out. (See Diagram 2.
6. Disconnect the inlet gas line.
7. Disconnect the EV1, EV2, and ground wires from the valve - as shown
below.
Diagram 3
Regency HZ33CE Gas Fireplace
VALVE TRAY REPLACEMENT
Diagram 2
Ground
EV1
EV2
8. Remove the 12 screws securing the valve tray assembly in place
(Diagram 4. and then lift the entire assembly out (Diagram 5..
NOTE: Parts have been hidden to shown screw locations.
Diagram 4
Diagram 5: Lift out Valve Tray Assembly
Installing Valve
1. Install new Valve Tray Assembly.
2. Reverse steps 8-1.
MAINTENANCE
53
Advertisement
Table of Contents
