Configuring The Number Of Quick Memory Channels; Clearing Quick Memory Channels; Memory Shift (Quick Memory To Vfo) - Kenwood TS-990S Instruction Manual

CONFIGURING THE NUMBER OF QUICK
MEMORY CHANNELS
This transceiver has 10 Quick Memory Channels (Q0 to
Q9). However, you can adjust the maximum number of
available Quick Memory Channels.
1 Select Group No. 4, "Memory Channels & Scan", from
the Menu screen.
2 Access Menu 00, "Number of Quick Memory
Channels".
3 Press [SELECT] (F4) to enable editing of the
parameter box.
4 Press [–] (F4) or [+] (F5) to select "3 [ch]", "5 [ch]", or
"10 [ch]".
The default is "5 [ch]".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ When the configuration of Number of Quick Memory Channels
is decreased, the oldest operating data is cleared from the Quick
Memory Channel (the data with the largest Quick Memory Channel
number).
Contents Index

CLEARING QUICK MEMORY CHANNELS

You can clear all operating data configured in Quick
Memory Channels.
[F1] [F7]
1 Press [MR] (Quick Memory) to call the Quick Memory
Channels.
2 Press and hold [MR] (Quick Memory).
A message appears prompting you to clear all operating data
configured in Quick Memory Channels.
3 Press [OK] (F4) to clear the operating data.
• All operating data in the Quick Memory Channel is cleared
and VFO mode is selected.
• Press [CANCEL] (F7) to close the message without
clearing the operating data in the Quick Memory Channels.

MEMORY SHIFT (QUICK MEMORY TO VFO)

You can copy the operating data of a Quick Memory
Channel to VFO.
1 Press [MR] (Quick Memory) to recall the Quick
Memory Channels.
2 Rotate the MULTI/CH control to select a Quick
Memory Channel to which the operating data will be
copied.
3 Press [M V] or [
• Operating data in the Quick Memory Channel is copied to
VFO and VFO mode is selected.
• If an operating data is changed temporarily, the changed
operating data is copied to VFO.
Note:
◆ If the operating data is temporarily changed, the temporarily
changed operating data is copied to VFO.
◆ When the operating data is copied to VFO, the operating data
copied to VFO until then will be overwritten.
MEMORY CHANNELS 10
[MR]
] (F6).
10-9