Selecting A Memory Channel; Temporarily Changing The Operating Data; Temporarily Changing Frequency - Kenwood TS-990S Instruction Manual

SELECTING A MEMORY CHANNEL

The Memory Channel selected for main band and sub
band can be switched individually.
1 Press [<MAIN] to select a main band Memory Channel
or [SUB>] to select a sub band Memory Channel.
2 Press [UP] (microphone) or [DOWN] (microphone),
or rotate the MULTI/CH control to select a Memory
Channel.
Note:
◆ In Dual-band Memory Channel mode, the Memory Channels of
both bands are switched simultaneously whichever the band is
selected.
DIRECTLY ENTERING THE MEMORY CHANNEL
NUMBER
The channel number for single-band Memory Channel or
dual-band Memory Channel can be selected using the
numeric and band select keypad.
1 Press [<MAIN] or [SUB>] to select a band.
2 Enter the number on the tenths for the Memory
Channel with a numeric key.
The number is displayed to the tenths digit for the Memory
Channel number of the selected band, and "-" (dash) is
displayed to the units digit.
3 Enter the number on the units digit for the Memory
Channel with a numeric keypad.
• The operating data for the corresponding channel number
is diverted and channel number entry ends.
• Press [CLR] to cancel entry and the Memory Channel
number entry ends.
Note:
◆ In Dual-band Memory Channel mode, when the operating data is
diverted for a band, the unselected band also receives the data
from the same channel number.
◆ While the Quick Memory Channel is in use, the number of the
Quick Memory Channel cannot be configured.
Contents Index
TEMPORARILY CHANGING THE OPERATING
DATA
While using operating data configured in Memory
Channel, you can temporarily change the frequency and
other operating data without changing the operating data.
[F1] [F7] Mode keys

TEMPORARILY CHANGING FREQUENCY

Change the configuration as follows to temporarily change
the frequency.
1 Select Group No. 4, "Memory Channels & Scan", from
the Menu screen.
2 Access Menu 01, "Temporary Change (Memory
Channel Configurations)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On".
The default is "Off".
5 Press [ ] (F1).
6 Press [MENU] to exit.
7 Press [M/V] to enter single-band Memory Channel
mode or press and hold [M/V] to enter dual-band
Memory Channel mode.
8 Rotate the Tuning (M) control to change the frequency.
To configure the changed frequency, configure it to a different
Memory Channel. {page 10-2} {page 10-3}
Note:
◆ For the Program Memory Channels, the operating data configured
in the Memory Channel is updated when the frequency or mode is
changed regardless of this configuration.
◆ The operating data related to the operating mode and FM tone can
be temporarily changed regardless of this configuration.
MEMORY CHANNELS 10
Tuning (M) [MENU]
10-5