Rtty Parameters; Configuring The Mark Frequency; Configuring The Rtty Shift Width - Kenwood TS-990S Instruction Manual

5 ASSISTING YOUR SMOOTH QSO

RTTY PARAMETERS

CONFIGURING THE MARK FREQUENCY

You can configure the mark signal frequency used for
communication in RTTY (FSK) mode. The tone at 1275 Hz
is called low tone and the tone at 2125 Hz is called high
tone. The high tone is now more often used worldwide.
[F1] [F7]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 08, "FSK Tone Frequency".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "1275 [Hz]" or "2125
[Hz]".
The default is "2125 [Hz]".
5 Press [ ] (F1).
6 Press [MENU] to exit.
5-46

CONFIGURING THE RTTY SHIFT WIDTH

The difference in frequency between the mark signal and
the space signal is called shift width. You can configure the
shift width for communication in RTTY mode.
[MENU] [MULTI/CH]
1 Select Group No. 2, "Decoding & Encoding", from the
2 Access Menu 06, "FSK Spacing".
3 Press [SELECT] (F4) to allow editing of the parameter
4 Press [-] (F4) or [+] (F5) to select "170 [Hz]", "200
5 Press [
6 Press [MENU] to exit.
Note:
◆ You cannot change the RTTY shift width while the RTTY Encode/
◆ To operate in RTTY mode using the built-in demodulator, encoder
[F1] [F7]
Menu screen.
box.
[Hz]", "425 [Hz]", or "850 [Hz]".
The default is "170 [Hz]".
] (F1).
Decode screen is open.
and decoder, configure "170 [Hz]" for Menu 2-06, "FSK Spacing".
[MENU] [MULTI/CH]
Index Contents