Configuration For Psk Encoding And Decoding; Displaying The Time Stamp - Kenwood TS-990S Instruction Manual

disappears, the transceiver does not revert to the receive
mode after the PSK message for that channel is sent.
7 Press [ ] (F1).
8 Press [ESC] to exit.
Note:
◆ select the channel where the PSK message is stored. After you
confirm that a text string (PSK message) has been transferred to
the buffer of a text string, press [F12] of the USB keyboard.
◆ To place the transceiver in the receive mode after the PSK
message for which automatic reception is disabled, press [F12] of
the USB keyboard.
SENDING A TEXT STRING STORED IN PSK MESSAGE
MEMORY
You can transmit messages entered in the PSK message
memory.
[FSK/PSK/REV]
[F1] [F7]
1 Press [FSK/ PSK/ REV] to enter PSK mode.
2 Press [DECODER] (F3) to open the PSK Encode/
Decode screen.
3 Press [MEMORY] (F5) to open the PSK Message
screen.
If [MEMORY] (F5) is unavailable in the function key guide,
press [MORE] (F1). An alternate key guide will appear.
4 Press [CH1] (F3), [CH2] (F4), [CH3] (F5), [CH4] (F6),
[CH5] (F3), [CH6] (F4), [CH7] (F5), or [CH8] (F6) to
select the channel for which the message to be sent
has been stored.
• The PSK message will not automatically be transmitted
from the channel for which automatic transmission of the
PSK message is disabled
• The key guide for [F1] through [F7] are the key guide
for configuration, including [
(F2), [ ] (F3), [
[AUTO.TX] (F6), and [AUTO.RX] (F7). In this case,
press [MORE] (F2) so that the key guide will alternate
between the key guide for [
(F2), [CH1] (F3), [CH2] (F4), [CH3] (F5), [CH4] (F6),
and key guide for [NEXT] (F7) and the key guide for
[ ] (F1), [MORE] (F2), [CH5] (F3), [CH6] (F4),
[CH7] (F5), [CH8] (F6), and [NEXT] (F7).
• The transceiver enters the receive mode after the PSK
message displayed along with "AUTO RX" on the right side
is sent.
Contents Index
] (F1), [MORE]
] (F4), [MSG] (F5),
] (F1), [MORE]
CONFIGURATION FOR PSK ENCODING AND
DECODING

DISPLAYING THE TIME STAMP

You can display the timestamp whenever transmission and
reception alternate. You can display frequency information
as well as the timestamp.
[F1] [F7]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 13, "RTTY/PSK Time Stamp".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [–] (F4) or [+] (F5), or rotate the MULTI/CH
control to select either "Off", "Time Stamp", or "Time
Stamp + Frequency".
The default is "Time Stamp + Frequency".
5 Press [ ] (F1).
6 Press [MENU] to exit.
ASSISTING YOUR SMOOTH QSO 5
[MENU] [MULTI/CH]
5-59