Displaying The Subscope During Tx - Kenwood TS-990S Instruction Manual

5 Press [ ] (F2) or [
MULTI/CH control to select the desired file.
6 Press [OK] (F4) to start reading the configuration data.
• A message notifying you of the progress will appear. After
the configuration data has been read, another message
notifying you that the configuration data has been read will
appear.
• Pressing [CANCEL] (F7) returns you to the TX Equalizer
screen without reading the configuration data.
7 Press [OK] (F4).
8 Press [ESC] to exit.
Note:
◆ You must remove a USB flash drive after executing the Safe
Removal of USB Flash Drive.
◆ If TX Equalizer type selected at step 3 differs from the equalizer
type linked to the file to be read, the configuration data for
TX Equalizer selected at step 3 will be overwritten with the
configuration data for TX Equalizer to be read.
Contents Index
] (F5), or rotate the
{page 12-1}

DISPLAYING THE SUBSCOPE DURING TX

You can display the waveform on the subscope also
displaying the band width of TX filter while transmitting in
SSB, FM, or AM mode. This enables you to observe the
status of the transmitting audio.
1 Select Group No. 8, "Bandscope", from the Menu
screen.
2 Access Menu 01, "TX Audio Waveform Display (Sub
Screen)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On" (to display the
waveform on a sub scope.
The default is "On".
5 Press [ ] (F1).
6 Press [MENU] to exit.
The Sub Scoop with Waveform displayed
Note:
◆ While in transmitting, the configuration for Menu 8-01 cannot be
changed.
◆ The marker representing the center frequency of the notch filter or
the band elimination filter.
◆ Waveform does not appear on the subscope while an audio scope
is active in the main screen.
TRANSMIT FUNCTIONS 9
9-13