Channel To Channel Transfers; Erasing Memory Channels; Full Res@T Oo - Kenwood TS-870S Instruction Manual

9 MEMORY FEATURES
m@ Channel to Channel Transfers
1 Press [RX M.CH] to select Memory Recall mode.
2 Select the memory channel that contains the data
to be transferred.
3 Press [M.IN] to select Memory Scroll mode.
5 Press [M.IN].
4 Select the destination memory channel.
These tables illustrate how data is transferred
between memory channels.
Note:
Channel 99 Channel 00 ~ 98
TX/IRX RX frequency
frequency 7 | TX frequency
RX mode
TX mode >
TX mode
_ Sudtone
frequency
Channel lockout > Channel lockout
OFF/ON | OFF
¢ = ifamemory cnannel is recalled, then the recalied data is
changed but no! saved to the memory channel, pressing
IM.IN] in Step 5 transters the new data tc the destination
memory channel.
@ = Inthe FM mode. when channel 99 is copied to another
memory channel! (00 ~ 98), a Tone frequency of 88.5 Hz is
stored automatically in the destination channel.
ERASING MEMORY CHANNELS
This procedure erases all data from the selected
memory channel
Channel 00 ~ 98 md Channel 06 ~ 98 1 Press [RX M.CH] to select Memory Recall mode.
|_RX frequency » RX frequency
RX mode
|
>
RX mode
!
ed
TX frequency ; » TX frequency i ny i A i 5 5 Hf Gf
TX mode : bead TX mode | =
Pe a suns 'y Select the memory channel that contains the data
be use Maus that yh want to pa 7
3 Press [CLR] for approximately twa seconds.
Channe! lockout » , Channel lockout
OFF/ON ! OFF
Channel 00 ~ 98 -» Channel 99
TX/RX
RX frequency ™» frequency
Start frequency
RX mode! > TX/RX mode |
TX frequency »> End frequency
TX mode _
Subtone iw
frequency :
Channel lockout > Channel lockout
OFF/ON | OFF
A beep sounds to confirm that the channel data
erased.
@ Full Reset
Do a Ful! Reset if you want to erase all data in all
memory channels or if a Partial Reset {page 63}
does not correct a problem. Remember that a Full
Reset requires that you re-enter any memory
is
channel data again after the initialization if you want
to use these channels. A Full Reset also initializes
all electronic keyer settings to their default values.
Press [A=B]+ POWER ON.
57