Canon imageRunner 2220i User Manual page 149

5
1
6
7
1-128 Changing the Scan Settings
Set the binding erase width by pressing [–] or [+] © press
[OK].
When entering values in millimeters, you can use
and (Clear).
C
If you enter values with
values by pressing [–] or [+].
The specified mode is set, and the display returns to the Special Features screen.
NOTE
•
To enter values in millimeters, press [mm].
•
The default setting is '3/4" (18 mm)' for the binding erase width. The maximum
Frame Erase value is '13/16" (20 mm)'.
•
If you enter values outside the setting range, a message prompting you to enter an
appropriate value appears on the screen.
Press [Done] © [OK].
The display returns to the Send Basic Features screen.
Press (Start).
If the original is placed on the platen glass, follow the instructions that appear on
the touch panel display. Press
is complete, press [Done].
Scanning starts.
When scanning is complete, the document is sent to the specified destination.
- (numeric keys), you can change the entered
9
0
(Start) once for each original. When scanning
- (numeric keys)
9
0