Keypad Configuration Mode; Keypad Installation; Configuring The Keypads - NAPCO LIBRA LIB-P432EX Programming Instructions Manual

KEYPAD CONFIGURATION MODE

This section will focus on configuring the GEM-DXRP2 / GEM-DXK2, GEM-DXRP3 / GEM-DXK3 and GEM-DXK4RF
series keypads. For ease of programming, it is recommended that a GEM-DXRP1 or a GEM-DXK1 be selected (see
WI1690 for Programming Instructions using the GEM-DXRP1 or GEM-DXK1 keypads).

KEYPAD INSTALLATION

Each keypad must be assigned an address number (1–7) and each requires its own configuration procedure (see
CONFIGURING THE KEYPADS, which follows, and DIRECT ADDRESS KEYPAD AREA OPTIONS). At least 1
keypad must be used; only 1 is required for a single-area Commercial Burglary installation.
GEM-DXRP2 / GEM-DXK2 - Are utility LCD keypads combining several preset LCD words with a limited message
line. NOTE: Due to space constraints, available messages are abbreviated and will scroll automatically.

CONFIGURING THE KEYPADS

Configuring the GEM-DXRP2 / GEM-DXK2, GEM-DXRP3 / GEM-DXK3 and
GEM-DXK4RF Keypads
Up to 7 GEM-DXRP2 / GEM-DXK2, GEM-DXRP3 / GEM-DXK3 and/or GEM-DXK4RF keypads may be connected to
the panel (Keypads 1–7). Each must be configured for a keypad address. In addition, the keypad may be configured
to disable (a) touchpad backlight; (b) LCD backlight; and (c) entry
sounder. Keypads are configured by the proper selection of jumpers.
Refer to the label on the circuit board insulation paper for jumper
locations and a summary of settings.
KEYPAD ADDRESS
If more than one keypad is installed:
Each must be assigned a unique address (that is, no two keypads
may be numbered alike).
Keypads must be addressed consecutively (that is, missing
numbers are not permitted).
Assign the keypad address number by selecting Jumpers J1–3 in
accordance with the table at right.
TOUCHPAD BACK LIGHT
Cut Jumper A to disable touch pad backlighting to conserve 11mA standby current.
LCD BACKLIGHT
Cut Jumper B to disable LCD backlighting.
DISABLE SOUNDER
Cut Jumper C to disable the sounder.
NAPCO Security Systems
KEYPAD
NUMBER
1
2
3
4
5
6
7
LIBRA LIB-P432EX Series Programming Instructions
Page 55
KEYPAD ADDRESS SETTING
1 2 3 PARK
OFF or OFF OFF
ON
OFF ON OFF
STORE SPARE
ON ON OFF
JUMPER AT THIS
OFF OFF OFF
POSITION
ON OFF ON
OFF ON ON
ON ON ON