Important Note - NAPCO LIBRA LIB-P432EX Programming Instructions Manual

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN
CONTROL PANEL FIRMWARE VERSION 30K OR LATER.
This manual supports the keypad programming of the LIB-P432EX series control panels with the NAPCO GEM-
DXRP2, GEM-DXRP3, GEM-DXK2, GEM-DXK3 and GEM-DXK4RF Series Keypads. Compared with the "DXRP"
models, the "DXK Series" models offer simplified functionality with STAY (
different icon printed on the ENTER (
While the programming instructions in this manual are depicted using the "DXK Series" models, this manual also ap-
plies to the "DXRP" models because keypad Program Mode is identical for both types of keypads--only the button
icons are different, as follows:
v
• The
button and the
• The "Interior" (
p
pads. These buttons are also used to answer "YES" or "NEXT" to questions that appear on the keypad display;
on occasion, a checkmark "r" or a down arrow " " may be used in this manual as well.
• The "Instant" (
z
pads. These buttons are also used to answer "NO" or "PRIOR" to questions that appear on the keypad display;
on occasion, an "X" symbol or an up arrow " " may be used as well.
For consistency, it is recommended that all keypads used in one alarm system either be all type "DXRP" or all
"DXK Series" -- both keypad types should not be used in one alarm system.
The following applies to the LIB-P432EXT and LIB-P432EXT-230 control panels only:
Telephone Connection
The LIB-P432EXT and LIB-P432EXT-230 products under the R&TTE Directive 99/5/EC complies with the CTR21 regulation and may be used on the
PUBLIC network with the following restrictions:
•
Do NOT use the ROTARY Dialing feature as this is not evaluated in CTR21.
Special Programming
•
Pulse dialing is NOT to be used. Programming location 0788 CS SYSTEM REPORT OPTIONS shall have the right digit entry always a 2 (=
Touch-Tone Dialing only). If using the option of "Disable Dial Tone Detect" in location 0788 then a 3 second pause must precede the "CS re-
ceiver telephone number" by entering a D before the telephone number.
•
Note: Address 1424, "Disable Code Required for EZ Bypass", the default panel configuration is "OFF".
WARNING: If using the EZ Driven Program Mode, be aware that all EN501 defaults will be deleted.
Refer to page 56 of the Installation Instructions (WI1691) for setting the EN50131-1 features.

IMPORTANT NOTE

u
) button.
u
button operate identically (in Program Mode) for both keypads.
) button and the "STAY" (
) button and the "AWAY" (
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
) button operate identically (in Program Mode) for both key-
p
) button operate identically (in Program Mode) for both key-
q
NAPCO Security Systems, Inc.
) and AWAY (
p q
) buttons, and a