Keypad Configuration Mode; Configuring The Keypads - NAPCO Gemini GEM-P3200 Programming Instructions Manual

WI1184B 2/06

KEYPAD CONFIGURATION MODE

This section will focus on configuring the GEM-RP2ASe2/GEM-K2AS, GEM-RP3DGTL/GEM-K3DGTL, GEM-
RP4RFC/GEM-K4RF, and GEM-RP4C/GEM-K4 series Keypads. If there is more than one keypad in the system, only
Keypad No. 1 may be used for programming. For ease of programming, it is recommended that a GEM-RP1CAe2 or
a GEM-K1CA be selected as Keypad #1 (see WI818 for Programming Instructions).
KEYPAD INSTALLATION
Each keypad must be assigned an address number (01–07) and each requires its own configuration procedure (see
CONFIGURING THE KEYPADS, which follows, and DIRECT ADDRESS KEYPAD AREA OPTIONS). At least 1
keypad must be used; only 1 is required for a single-area Commercial Burglary installation. Note: The GEM-
RP2ASe2/GEM-K2AS keypads are utility LCD keypads combining several preset LCD words with a limited message
line. Due to space constraints, available messages are abbreviated and will scroll automatically.

CONFIGURING THE KEYPADS

Configuring the GEM-RP2ASe2/GEM-K2AS, GEM-RP3DGTL/GEM-K3DGTL, GEM-
RP4RFC/GEM-K4RF and GEM-RP4C/GEM-K4 Keypads
Up to 7 GEM-RP2ASe2/GEM-K2AS, GEM-RP3DGTL/GEM-K3DGTL, GEM-RP4RFC/GEM-K4RF and/or GEM-RP4C/
GEM-K4 series keypads may be connected to the panel (Keypads 01–07). Each must be configured for a keypad
address. In addition, the keypad may be configured to disable (a) touchpad backlight; (b) LCD backlight; and (c) entry
sounder. Keypads are configured by the proper selection of jumpers. Refer to the label on the circuit board insulation
paper for jumper locations and a summary of settings.
KEYPAD ADDRESS
If more than one keypad is installed:
Each must be assigned a unique address (that is, no two keypads
may be numbered alike).
Keypads must be addressed consecutively (that is, missing
numbers are not permitted).
Only Keypad No. 1 may be used for programming. (However, for
ease of programming, it is recommended that a GEM-RP1CAe2/
GEM-K1CA be selected as Keypad #1).
Assign the keypad address number by selecting Jumpers J1–3 in
accordance with the table at right.
*Notes: (1) Keypads are shipped from the factory without jumpers
installed and as such are automatically configured as Keypad No. 1. (2) Only one keypad in the system may be
configured as Keypad No. 1, otherwise none will function.
TOUCHPAD BACK LIGHT
Cut Jumper A to disable touch pad backlighting to conserve 11mA standby current.
LCD BACKLIGHT
Cut Jumper B to disable LCD backlighting.
DISABLE SOUNDER
Cut Jumper C to disable the sounder. (Do not disable in UL applications).
L
NAPCO Security Systems
KEYPAD KEYPAD ADDRESS SETTING
NUMBER
1 2
1 OFF or OFF OFF
ON*
2 OFF ON
3 ON ON
4 OFF OFF OFF
5 ON OFF
6 OFF ON
7 ON ON
X
GEM-P3200 Programming Instructions
Page 65
PARK
3
OFF
STORE SPARE
OFF
JUMPER AT THIS
POSITION
ON
ON
ON