Audio Setup Menu - Sony IPELA PCS-XG100 Operating Instructions Manual

Audio Mode
Allows you to select the compression format
of audio to be sent to a remote party.
You can select from among G.728, G.722
and G.711.
Note
When the remote system does not support the
audio mode selected by the local site, the mode
automatically becomes "G.711".
Far End Camera Control
Allows you to select whether to enable the
control of each other's cameras from each
other's site.
On: Enables the control of each other's
cameras. Normally, set to "On".
Off: Disables the control of each other's
cameras.
Screen Size
Allows you to select the screen size of the
picture to be transmitted or received.
You can select from among 720, W4CIF,
W432P, WCIF, 4CIF, CIF, QCIF and
AUTO.
Video Mode
Allows you to select the compression format
of pictures to be transmitted or received.
You can select from among H.261, H.263+,
H.264 and MPEG4.
Note
"H.261" will be supported in version 2.0.
Video Frame
Allows you to select the number of video
frames during transmission or reception.
MIC (A1)15fps: Send pictures at a
maximum rate of 15 frames per second.
30fps: Send pictures at a maximum rate of
30 frames per second.
60fps: Send pictures at a maximum rate of
60 frames per second.
AUTO: Switch the number of frames
automatically.
Note
When using PCSA-CXG100 or EVI-H100V
HD camera units, transmission will be at a
maximum of 30 frames per second, even when
"Video Frame" is set to "60fps" or "AUTO".
72
Registering Local Information

Audio Setup Menu

The Audio setup menu is used to set various
audio items.
Audio1
Basic Setup1
Audio Input
Allows you to select the audio input.
MIC: Inputs audio from the microphone.
AUX: Inputs audio from auxiliary external
equipment.
MIC+AUX: Inputs audio from the
microphone and auxiliary external
equipment.
Note
When "Link to Audio Input" is set to "On" in
the Video setup menu, "Audio Input", "Input
Select (MIC)" and "Input Select (AUX)"
cannot be selected.
Input Select (MIC)/
Input Select (AUX)
Allows you to select the microphone and/or
external equipment from which an audio
signal is input.
For the PCS-XG100/XG100S
The options that can be selected vary with
the Audio Input setting.
When you select "MIC" from "Audio
Input", you can select one of the following
three options. When you select "AUX", you
can select "AUDIO 1" or "AUDIO 2".
When you select "MIC+AUX", you can
select two options: one microphone input
from "MIC (A1)", "AUDIO 1" or "AUDIO
2", and one auxiliary external input from
"AUDIO 1" or "AUDIO 2".
Note
When "Video Input" is set to "HDMI" in the
Video setup menu, AUX audio will
automatically be set to the inputs from the
HDMI IN connector.
MIC (A1): Select use of the PCS-A1
microphone (supplied) connected to the
MIC (A1) jacks on the Communication
System.