Installing The Srg-120Dh Hd Camera Unit; Installing The Camera On A Desk; Attaching The Camera To A Tripod; Installing The Camera Using The M3 Fixing Screw Holes - Sony IPELA PCS-XG100 Operating Instructions Manual

Installing the
SRG-120DH HD
Camera Unit
Installing the Camera on a
Desk
Place the camera on a flat surface. If you
have to place the camera on an inclined
surface, make sure that the inclination is less
than ±15 degrees, and take measures to
prevent it from falling.
Notes
• Do not grasp the camera head when carrying
the camera.
• Do not turn the camera head by hand. Doing
so may result in a camera malfunction.
Attaching the Camera to a
Tripod
Use a screwdriver to tighten the tripod
attachment screw while using the following
as a guide for the amount of protrusion (4)
from the attachment surface.
4 = 4.5 – 7 mm
4 = 0.18 – 0.27 inches
Caution
Installation of the camera using the tripod
screws and screw holes should not be done
for installation on a ceiling or a shelf, etc., in
a high position.
Installing the Camera Using
the M3 Fixing Screw Holes
Attach the camera using three M3 fixing
screw holes located on the bottom of the
camera. Attach the camera to a fitting with a
flat surface using M3 screws with the
following specifications.
4 = 3 – 8 mm
4 = 1/8 – 11/32 inches

Installing the SRG-120DH HD Camera Unit

M3 screw
235