Sony IPELA PCS-XG100 Operating Instructions Manual page 41

2
Within 5 minutes of the Home menu appearing, bring the Remote
Commander as close to the Communication System as possible, press the
TOOLS and RETURN buttons at the same time, and hold the buttons for
at least 3 seconds.
The LED indicator flashes rapidly.
3
Press the ENTER button on the Remote Commander.
If the LED indicator flashes slowly 2 times, pairing between the units has
succeeded.
When pairing has failed
After about 30 seconds, the LED indicator on the Remote Commander flashes
slowly 5 times and then begins flashing rapidly. In this case, press the ENTER
button on the Remote Commander again.
To cancel pairing
Press the ^ / 1 (power) button on the Remote Commander. The LED on the
Remote Commander will switch from flashing rapidly to turning off.
Notes
• When the LED indicator does not flash even if you press any button on the Remote
Commander, the batteries might be exhausted. Replace both batteries with new ones.
• Once pairing is established between the units, it will not be erased even if the batteries
are replaced.
• The operating range for the Remote Commander is 10 m. Depending on conditions,
this range may be larger.
Preparing the System
41