Annotation Setup Menu; Camera Setup Menu; General Setup Menu - Sony IPELA PCS-XG100 Operating Instructions Manual

For the NTI DMS-100 (National
ISDN), NTI DMS-100 (Custom
ISDN), AT&T 5ESS (National ISDN)
switch type
Enter the different SPID numbers in
the A1 and A2 text boxes.
For the AT&T 5ESS (Point-to-Point
Custom ISDN) switch type
You do not need to set up the SPID,
then no entry in the A1 and A2 (B1
and B2, C1 and C2, depending on the
number of lines you use) is required.
5
After the settings are completed,
select "Save", then press the ENTER
button.

Annotation Setup Menu

The Annotation setup menu is used for the
annotation function allowing you to write
letters or graphics on the screen using a pen
tablet.
Annotation
Annotation
Enable
Allows you to select whether the annotation
function is enabled.
On: Enables the annotation function.
Off: Disables the annotation function.
Color
Allows you to select the color of the letters
or graphics written on the screen with a pen
tablet.
You can select from among "Black", "Red",
"Blue", "Green", "Yellow", "Orange",
"Purple" and "White".
Line Density
Allows you to select the density of the line
written on the screen with a pen tablet.
You can select from among "Thick",
"Medium" and "Thin".

Camera Setup Menu

Camera
Camera
Second Camera Input
Allows you to select the input connector on
the Communication System to which the
second camera is connected.
DVI-I 1: Connects the second camera to the
DVI-I 1 IN connector.
DVI-I 2: Connects the second camera to the
DVI-I 2 (PC) IN jacks.
HDMI: Connects the second camera to the
HDMI IN connector.
Note
The "HDMI" setting is not available on the
PCS-XG77/XG77S.

General Setup Menu

General1
Device Setup
Terminal Name
Input the local terminal name transmitted to
a remote party (up to 30 characters).
Standby Mode
Allows you to select whether the
Communication System enters standby
mode if it is idle for a specified period of
time.
On: Allows the System to go on standby.
Off: Does not allow the System to go on
standby.
Standby Time
Specify the time the system must remain idle
before entering the standby mode. This time
can be set between 1 and 99 minutes.
For details on the standby mode, see
"Standby Mode Function" on page 43.
Registering Local Information
87