Pcsa-Cxg100 - Sony IPELA PCS-XG100 Operating Instructions Manual

PCSA-CXG100

Note
This camera unit is not supplied with the
PCS-XG100/XG77/XG100S/XG77S
Camera
Front
2
a Lens
This is a 20-magnification optical zoom
lens.
b POWER lamp
Lights when the camera is connected to
an AC outlet using the supplied AC
power adaptor and AC power cord.
Flashes in green when the camera
receives an operation command from the
supplied remote commander.
It takes about 7 to 16 seconds to display
the image after the lamp lights.
c STANDBY lamp
Lights when the camera is turned off
using the remote commander.
238
HD Camera Unit Parts Identification
.
1
3
Rear
4 5 6 7
8 9
d Remote sensors
Used only for servicing.
e IMAGE FLIP switch
Flips the image upside down. Normally
set this to OFF when you use the camera.
When the camera is attached to the
ceiling, set this to ON. Before you set the
IMAGE FLIP switch, turn off the
camera (or set to standby mode) and
then, turn the power on by connecting
the power adaptor or by using VISCA
control or the remote commander. When
you switch this, the preset setting is
returned to the initial setting.
f IR SELECT switch
Used only for servicing.
g VISCA RS-422 connector
Used only for servicing.
h SYSTEM SELECT switch
0 qa qs