Communication Setup Menu - Sony IPELA PCS-XG100 Operating Instructions Manual

For details, see "Chapter 6: Multipoint
Connection" on page 189.
Multipoint
Multipoint
Multipoint Mode
AUTO: Switches from point-to-point
connection to multipoint connection
automatically.
On: Enables you to make a multipoint
connection at any time.
Broadcast Mode
Allows you to select the broadcast mode.
Split: Displays the picture from the
connected terminals in split windows.
Voice Activate: Detects the terminal where
a speaker has the loudest voice, and
automatically transmits the picture of
this terminal to all other terminals.
Voice Activate (1080P): Enables
transmission of pictures with resolution
of 1080 (1920 × 1080 pixels) in H.264
Video Mode when "Voice Activate"
mode is activated.
Notes
• The "Voice Activate (1080P)" mode cannot
be selected when the communication is made
via an ISDN or SIP connection. Even for an
IP connection, this mode is not available if
the remote party does not support H.264
Video Mode.
• When "Broadcast Mode" is set to "Voice
Activate (1080P)", you cannot change
"Broadcast Mode" during communication.
Select the Broadcast Mode before starting
communication.
Split
Allows you to select the type of split display
used to display local and remote pictures on
a single monitor during a multipoint
connection.
Automatic: The display automatically splits
into three parts when there are two
terminals connected, four parts when
there are three, six parts when there are
four or five, and nine parts when there
are six to eight terminals connected.
68
Registering Local Information
Six-screen Mosaic: The display is split into
six parts regardless of the number of
terminals connected.
Nine-screen Mosaic: The display is split
into nine parts regardless of the number
of terminals connected.
Note
When there is only one terminal connected, the
display switches to full screen regardless of the
selection of the setting.

Communication Setup Menu

The Communication setup menu is used to
set up communications.
Note
The contents of the Communication menu vary
with "Line Interface" setting in the Line I/F
setup menu, or "Individual Settings for
Transmission/Reception" or "Individual
Settings for Point-to-Point/Multipoint" setting
in the Communication setup menu.
The Communication page number after the
Communication2 page also varies according to
the number of setting items.
Communication
IP
The menu is used to set up the
communication mode for the IP connection.
Individual Settings for Transmission/
Reception
Allows you to select whether to configure
the IP settings for transmission and
reception individually.
Off: Select to configure the IP settings for
transmission and reception commonly.
On: Select to configure the IP settings for
transmission and reception individually.
Individual Settings for Point-to-Point/
Multipoint
Allows you to select whether to configure
the IP settings for a point-to-point
connection and multipoint connection
individually.
Off: Select to configure the IP settings for
both connections commonly.