Table of Contents
Advertisement
Machine head
4.6.4 Setting the foot stroke to the needle stroke
Fig. 30: Setting the foot stroke to the needle stroke
(1) - Lever
(2) - Lifting gear
(3) - Eccentric
Proper setting
The lifting gear (2) must be switched on so that it performs a stroke. The
stop block (6) must then lie against the right hand stop screw (5).
The eccentric (3) for the presser foot must be set so that
1. Switch the machine off and on again.
2. Reference the machine.
Service Instructions 911-211 - 00.0 - 02/2015
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Test and adjust the foot stroke to the needle stroke
only with very great care.
①
④
• when the needle bar is at bottom dead center - the presser foot is
lowered
• after the loop stroke - the presser foot stroke starts.
②
③
⑤
⑥
(4) - Sewing foot
(5) - Stop screw
(6) - Stop block
35
Advertisement
Table of Contents
